You see the lap details in the right half of the display. It comprises:
– the time of the fastest lap,
– the current lap time,
– information on the remaining tank range (in remaining laps and as a distance) as well as
– the available remaining memory.
The left half of the display shows a circle diagram.
It indicates the distance covered referred to a
The circle diagram assumes different colors
depending on whether the current lap is faster, as
fast as, or slower than the previous fastest lap:
– green - current lap is faster,
– yellow - current lap is as fast,
– red - current lap is slower.
The number in the center of the colored circle
indicates the current lap.
The first recorded lap is used as the reference
lap if you have not loaded an existing
Neither the remaining number of laps nor the
fastest lap time is displayed while the first lap
is being recorded. The circle diagram is not
filled yet either.
Available memory is full
If the available memory is full, a message to this
effect appears in the display. The lap details will
continue to be displayed, however the lap during
which the message appears as well as any further
laps will no longer be recorded.
A maximum of 8 hours can be recorded.
You stop the stopwatch and therefore the
recording in progress by selecting "Stop timing" in
the on-board computer menu.
The recorded data is stored.
You are returned to the Sport display the next time
you restart the stopwatch by means of "Continue"
in the on-board computer menu.
This is only possible, however, if you do not reset
the stopwatch in the on-board computer menu.
Ending a lap/starting a new lap
Selecting "Intermediate time" > "New lap?" in the
on-board computer menu ends one lap and starts
a new lap.
"Interval" initiates timekeeping and "New lap"
initiates storage (storage must take place within 3
Timing the interval
Selecting "Intermediate time" in the on-board
computer menu and then pressing the operating
lever forwards displays the interval for approx. 5