1. Press the button.
2. Press the button or touch the tab of the same name in the header.
3. Select "Rear view camera".
4. Select ""Automatic" to switch the function on ( ) or off ( ).

Retracting the rear view camera automatically
If the "Automatic" function is switched on, the rear view camera automatically retracts under the following conditions:
– If reverse gear is disengaged again, the rear view camera is retracted after 30 seconds or after a vehicle speed of
approx. 10 mph is exceeded.
It is only possible to extend the camera again when the vehicle speed has returned to below this limit.
– If the parking brake pedal is operated.
– If the PCM is switched off.
– If the engine is switched off.
– If the vehicle tailgate is opened.
After the rear view camera is retracted, the original PCM display is shown again.

Picture settings for the rear view camera

Setting the Brightness

1. Press the button.
2. Press the button or touch the tab of the same name in the header.
3. Select "Rear view camera"
   > "Picture param. - RVC"
   > "Brightness".
4. Make the desired setting by selecting the two symbols and or by turning the right rotary knob .
5. If the rear view camera is automatically activated, select "Back to RVC" to finish setting the picture parameters and to return to the camera image.

Setting the Contrast

1. Press the button.
2. Press the button or touch the tab of the same name in the header.
3. Select "Rear view camera"
   > "Picture param. - RVC"
   > "Contrast".
4. Make the desired setting by selecting the two symbols and or by turning the right rotary knob .
5. If the rear view camera is automatically activated, select "Back to RVC" to finish setting the picture parameters and to return to the camera image.

Setting the Color

1. Press the button.
2. Press the button or touch the tab of the same name in the header.
3. Select "Rear view camera"
   > "Picture param. - RVC"
   > "Color".
4. Make the desired setting by selecting the two symbols and or by turning the right rotary knob .
5. If the rear view camera is automatically activated, select "Back to RVC" to finish setting the picture parameters and to return to the camera image.