Quick Search: Choose Model and Year, then enter search topic.
A partially engaged parking brake may allow the vehicle to roll, causing serious personal injury or death to any person in its path.
Releasing the parking brake
Parking brake warning light USA
Parking brake warning light Canada
The warning lights in the instrument panel and onboard computer will go out after the parking brake is fully released.
The warning lights are not an indicator that the parking brake is fully set; it is only intended to be a warning to release the parking brake before driving the car.
A partially engaged brake will overheat the rear brakes, reduce their effectiveness and cause excessive wear.
Keep in mind that the braking distance increases very rapidly as the speed increases. At 60 mph or 100 km/h, for example, it is not twice but four times longer than 30 mph or 50 km/h. Tire traction is also less effective when the roads are wet or slippery.
Vehicles without Porsche Ceramic Composite Brake (PCCB)
Even though the brake discs consist of alloyed grey cast iron, they will unavoidably start to corrode if your car is parked for an extended period. The brakes will tend to "rub" as a result. The nature, extent and effects of corrosion depend on the amount of time the vehicle was parked, whether granular or liquid road salt was spread and whether grease-dissolving agents were used in car washes.
To prevent corrosion of the brake discs, "brake them dry" before parking the car.
If the braking comfort is noticeably impaired, we recommend having the brake system checked by experts at an authorized Porsche dealer.
Brake system function
Your Porsche is equipped with a power assisted hydraulic dual circuit brake system with disc brakes at the front and rear.
Both circuits function independently. One brake circuit operates the front and the other operates the rear.
If one brake circuit has failed, the other will still operate. However, you will notice an increased pedal travel when you apply the brakes.
Failure of one brake circuit will cause the stopping distance to increase.
Brake Hydraulic Failure Recovery
Your vehicle is equipped with an emergency function in the extreme event of a complete hydraulic failure of the brake system. If your brake pedal goes all the way to the floor, do not pump the brakes.
Brake system warning light
You can check the functionality of the brake system warning light by switching the ignition to the "On" position and verifying that the warning light illuminates.
Brake warning light USA
Brake warning light Canada
If the warning lights in the instrument panel and onboard computer go on while driving, the brake fluid level may be too low, or (if the brake pedal travel has increased) one of the two brake circuits may have failed.
A greater braking pressure will be required, stopping distances will be longer and the braking behavior will change, particularly in curves.