Limits of ultrasonic measurement
The parking assistant system cannot detect:
– sound-absorbing obstacles (e.g. powder snow),
– sound-reflecting obstacles (e.g. glass surfaces, flat painted surfaces)
– and very thin obstacles.
– Other ultrasound sources (e.g. pneumatic brakes of other vehicles, jackhammers) can interfere with detection of obstacles.

Fault indication
The parking assistant system indicates a fault in two ways:
– After reverse gear has been selected, the short signal tone is followed by a continuous tone of the same pitch:
This indicates that sensors are soiled or covered with ice.
– After reverse gear has been selected, the short signal tone is followed by a continuous tone with a much lower pitch:
This indicates a general system fault.
Please have the fault remedied at an authorized Porsche dealer.

A - Control switch for door mirror adjustment

Swivelling down mirror glass as a parking aid

• Please see the chapter "SEAT MEMORY" on page 26.

– When reverse gear is engaged, the mirror glass on the passenger's
side swivels down slightly to show the curb area.

Preconditions
– Vehicle must be equipped with seat memory.
– Set the control switch A to "passenger's side".
– Reverse gear must be engaged.

Returning mirror glass to its original position

• Drive forwards with a speed of over 4 mph (6 km/h) or
• Set the control switch A to "driver's side".
  
  
  

O - Initial position
1 - Ignition on
2 - Start engine
3 - Ignition off

Ignition/Starter Switch with anti-theft Steering Lock
The ignition lock has a total of four ignition lock positions.

The ignition key rebounds to the initial position from every ignition lock position.

• For your safety, fasten safety belts.
• Please see the chapter "IMMOBILIZER" on page 14.
• Please see the chapter "KEY WITH RADIO REMOTE CONTROL"
  on page 14.