Wheels with Tire Pressure Monitoring (TPM) sensors
Removing and storing tires
Tires must always remain on the same side of the vehicle.
When wheels are removed, the direction of rotation and position of each wheel should be marked.
FR (front right), FL, RR and RL.
Wheels must always be fitted in accordance with their marking.
The perception that tire durability and performance are immune to the effects of storage and age is unfounded.
Chemical additives, which make the rubber elastic, lose their effectiveness in the course of time and the rubber becomes brittle and cracks.
Therefore, the tires should be inspected from time to time.
Under no circumstances should tires older than 6 years be used on your Porsche.
The age of the tire can be obtained from the "DOT" code number. If, for example, the last four numbers read 1208, then the tire was produced in the 12th week of 2008.
Snow Tire Use
The standard tires profile and rubber mixture are optimized for wet and dry driving conditions, and may not be safe for snow conditions.
Before mounting snow tires, consult with your Porsche dealer. He has the technical information necessary to advise you on wheel and tire compatibility.
Snow tires should have the same load capacity as original equipment tires and should be mounted on all four wheels.
Driving the vehicle with low tire pressure increases risk of a tire failure and resulting loss of control. Furthermore, low tire pressure increases the rate of wear of the affected tires and causes damage. Tires with badly worn treads are very dangerous and could cause accidents.
Comply with all state and local laws governing snow tire and tread depth requirements.
Excessive Speed for Tires
Exceeding the maximum permitted speed for the tires fitted could cause tire failure.
We recommend fitting snow tires on the vehicle at temperatures below 45 °F (7 °C) since the driving performance of summer tires is reduced at low temperatures. Summer tires may be permanently damaged at extremely low temperatures.
Winter tires lose their traction capability when their tread depth falls below 5/32 in. (4 mm).