The "Call waiting" function is only available if
supported by the network provider.
The "Call waiting" function must also be activated
in the call settings of the PCM or the cell phone.
To find out more, please refer to the section "Call
waiting (swapping) and conference" on page 59.
Rejecting a waiting call
If you receive another call while there is already
one active, you will hear a call waiting tone.
The menu for the incoming call is displayed and a
message appears in the bottom line.
The waiting call is rejected. The caller hears the busy signal.
If the caller's telephone number is transmitted, the number or name appears in the "Received calls" list.
Accepting a waiting call
The waiting call is accepted and activated. The
previously active call is put on hold.
You then have the option to switch between the
two calls or to hold a conference with both
callers. To find out more, please refer to the
section "Call waiting (swapping) and
conference" on page 59.
The PCM will not accept a third incoming call.
The caller hears the busy signal or is redirected to
Ending an active call
Select "End active call".
The currently active call is ended and the first call that is on hold is activated again.
Call waiting (swapping) and conference
The "Call waiting & conf." function is only available
if supported by the network provider.
When using the Bluetooth hands-free unit, this
function is only available for a limited selection of
A prerequisite for this function is that there are two
calls, one of which is active and one of which is on
hold (inactive). To find out more about this, please
refer to the sections "Establishing an additional
call" on page 58 and "Accepting a waiting call" on
Select "Call waiting & conf.".
You now have a number of options: